Guntermann & Drunck CATCenter X systems Operation - Manual (Page 26)

Guntermann & Drunck GmbH CATCenter Operating Manual
Page 26
The hotkey combinations within this menu are predefined and cannot be
edited. Modifying the initial hotkey (
CTRL ) (see Chapter 5.8.1 ) to access
AdonIS has no effect on the valid hotkey combinations in this menu.
The entries in the OPERATION menu are accessible to all users. Exception:
Mouse utility; only for users with corresponding rights.
The entry Temporary OAC login (see Chapter 5.6.2.3 ) is only visible when
OpenAccess has been activated on the CATCenter system. This entry is only
available to the administrator or user with configuration rights when
OpenAccess has been activated. For notes regarding OpenAccess, see
Chapter 5.6.2 .
Depending on your rights, you access additional main menus from the
OPERATION menu. In particular, these are:
ESC Switches back to the SELECT menu
F10 Switches to the PERS. PROFILE menu
F11 Switches to the CONFIG menu
F12 Switches to the INFORMATION menu
3.1 Automatically pass through all targets
Activating the AutoScan function pass through all channels (targets) to which
the user has access.
Targets that are not turned on can also be included in the AutoScan function
(e.g. to check the boot phase of a target that has just been turned on).
3.1.1 Calling the AutoScan Function
Carry out the following steps:
1. Access AdonIS by pressing the key combination (default): CTRL +
NUM
2. Access the OPERATION menu by pressing the F9 key.
3. Move the cursor to the entry AutoScan and press the ENTER key or
the A key.
Alternatively, the function can be called from the SELECT menu using the
hotkey combination
CTRL + A.
The channels you have access to are connected to your console, one after the
other, for approx. 5 seconds. The time period can be modified (
see chapter
4.2 ).
In the delivery condition, all computers are enabled for the AutoScan function.