GAI-Tronics MRTI 2000 (No. PL1877A) Microprocessor Radio Telephone Interconnect Installation & Service Manual - Manual (Page 71)

PL1877A Microprocessor Radio Telephone Interconnect Operator Instructions
65 12/10
The following is a list the mobile commands:
Abbreviated Mobile Commands Chart
N OTE : All multi-digit commands must be entered with a maximum of 1 second inter-digit time.
Standard Commands
* (or #*) Access telephone line (#* if set by parameters)
# (or ##) Release telephone line (## if set by parameters)
** Redial last number called
*** Overrides line busy
*** After access = refresh/reset overall access timer
n**# Station/repeater enable command (n = station/repeater enable prefix)
*#* Before access = answer if called (special applications
*#* After access = flash (momentary on-hook to regain dial tone where applicable
*1* TX PL tone on
*1# TX PL tone off
n* Multi-digit access code: n = 1–6 digits
#n Multi-digit access code: n = 1–6 digits
*0#n Executive override code: n = 1–6 digits (overrides a variety of programmed
restrictions
n*#0 Enter mobile, DTMF programming mode (n = remote parameter access code, 1–6
digits)
Auto-dial
*1 Patch dials stored telephone number 1
*9 Patch dials stored telephone number 9
*25 Patch dials stored telephone number 25
*0* Enter autodial programming mode
Selective Signaling Option
*##n Revertive (mobile-to-mobile) call where n is the capcode or user ID of the target
mobile
2nd Line Option
*2* Select line 2 for outbound call origination
*2# Select line 1 for outbound call origination (if line 2 is currently selected)