GAI-Tronics MRTI 2000 (No. PL1877A) Microprocessor Radio Telephone Interconnect Installation & Service Manual - Manual (Page 113)

PL1877A Microprocessor Radio Telephone Interconnect Parameter Modification
107 12/10
Para-
meter
No.
Description
Control Digits Refer to
Section on
Page:
46 Allows 9 as the first telephone digit. 0 = Don’t allow
1 = Allow 97
47 Allows 1 as the first telephone digit. 0 = Don’t allow
1 = Allow 97
48 Allows 0 as the first telephone digit. 0 = Don’t allow
1 = Allow 97
49 Determines whether toll restriction applies
to auto-dial numbers. 0 = Does not apply
1 = Applies
Default = 0 98
50 Determines whether * access command is
required from a landline user on line 1
before allowing direct channel access or
selective signaling input. 0 = Don’t require
1 = Require
Default = 1 101
51 Determines whether * access command is
required from attendant user before
allowing a direct channel access or
selective signaling input. 0 = Don’t require
1 = Require
Default = 1 101
52 Enable or disable SID on patch release. 0 = Disable
1 = Enable 95
53 Determines whether the mobile user is
restricted to using the auto-dial feature for
dialing telephone numbers. 0 = Don’t restrict
1 = Restrict
Default = 0 98
54 Allows a mobile user to access a busy
phone line with the *** command. 0 = Don’t allow
1 = Allow
Default = 0 103
55 Enables/disables mobile modification of
auto-dial numbers.
0 = Disable
1 = Enable
Default = 1 90
56 Determines whether the station/repeater
enable feature is enabled or disabled. 0 = Disable
1 = Enable
Default = 0 103
57 Enables or disables a mobile users ability
to modify parameters with a DTMF
keypad. 0 = Disable
1 = Enable
Default = 0 90
58 Enable or disables landline direct channel
access. 0 = Disable
1 = Enable
Default = 0 99
59 Enable or disables attendant direct channel
access. 0 = Disable
1 = Enable
Default = 0 99