Formax 6404 Series - Manual (Page 98)

Clean and replace brushes
When dirty or saturated, clean the brushes of the envelope sealing or replace them as
follows:
1.
Moisten the new brushes in water.
2. Remove the brushes one by one by pulling them down from the brush holder.
3. Replace the brushes. Make sure that the studs on the brushes are fitted in the
corresponding holes in the brush holder.
Replace or clean moistening cloth
When dirty or saturated, clean the moistening cloth or replace if necessary. Proceed as
follows:
1.
Remove the sealing liquid reservoir from the system.
2. Remove the cover with moistening cloth B.
3. Remove clips A to remove the moistening cloth.
4. Clean or replace the cloth.
9
En
glish
91
| Page 91 | jan-06-2012 13:58 |