Formax 6404 Series - Manual (Page 73)

Flap Closer Offset
To change the flap closer offset for a selected job:
1.
Use the arrows next to "Select job" to select for which job (Job 1-25 or Auto) you want
to make the changes.
2. Use the arrows next to "Flap Closer offset" to change the Flap closer offset for the
selected job.
The offset can be varied between -20 and 20. If for example the offset is set to +10
the sealing process will be activated 10 pulses later than initially.
3. Press the [Save] button to save the changes to the selected job.
Envelope Clearing
To define when envelopes are cleared:
1. Use the next to "Job selection" to set wether the envelopes should be cleared
(always, never or only after asking) when the operator selects a job.
2. Use the next to "Edit job" to set wether the envelopes should be cleared (always,
never or only after asking) after the operator has edited a job.
3. Press the [OK] button to accept the changes.
66
| Page 66 | jan-06-2012 13:58 |
6
En
glish