Formax 6404 Series - Manual (Page 28)

Options 3
Production Feeder
The production feeder is a feeder that can be loaded with a high number of documents. This
feeder is intended to be used for Business Reply Envelopes (BRE), but also 'standard'
documents up to 356 mm (14") length can be processed with it.
Installing the Production Feeder
The production feeder should be installed at the position of feeder no. 1 and/or 4. If you
install it on position 4, you cannot use position 2 and 3 for document feeders.
To install the production feeder as follows:
1.
Lift the paper feed rollers with the front edge of the production feeder.
2. Move the production feeder forward until it hooks behind the frame axle.
3. Connect the connector A to the socket B.
The production is auto-detected by the system when the system is switched on.This
makes it easy to switch over from the standard document feeder tray to the production
feeder and vice versa.
To make use of a production feeder it is not necessary to (re-)program the jobs.
To allow easier hooking on of the production feeder it is advised
to put the feeding plate in the rear position.
21
| Page 21 | jan-06-2012 13:58 |
3