Operator troubleshooting, Trouble shooting table, En glish – Formax 6404 Series User Manual
Page 108
![background image](https://www.manualsdir.com/files/785537/content/doc108.png)
3.
Lower the collator arm.
4.
Press the
[Reset] button to reset the error and restart the job.
Operator Troubleshooting
To resolve problems:
1.
Write down the error.
2.
Try to solve the problem by consulting the troubleshooting table.
3.
Switch the inserter off and on again, to verify system operation.
4.
When the error still occurs contact your service organization.
When contacting the service organization, you will also be asked
for the last error message and the software version of the installed
software. To determine the software version, see Viewing System
info and Software versions.
Trouble Shooting Table
Reference
Remedy
Possible cause
Symptom
-
Connect the system
to the mains.
System not connect-
ed to mains.
The system cannot
be started after
switching on.
-
Replace fuse below
power switch.
Fuse is blown.
-
Close the covers.
A cover is opened.
on page 17
Check envelope feed
adjustments. Place
envelopes correctly in
hopper.
Envelopes stacked
reversed in the hop-
per.
System stops with
envelope at insert po-
sition (flap not open).
on page 46
Store envelopes ac-
cording to specifica-
tions.
Envelope flap sticks.
on page 46
Change envelopes
according to specifica-
tions.
Wrong envelope type
used (not according
to specifications or
job settings).
10
En
glish
101
| Page 101 | jan-06-2012 13:58 |