Formax 6404 Series - Manual (Page 76)

2. Use the button next to BRE with window to set the BRE offset to On of Off.
If a document is longer than the set address fold but shorter than the envelope height,
this document sometimes will be unnecessarily folded. Under certain conditions this
document can be prevented from being folded. This can be implemented with the
menu “BRE offset” (BRE means Business Reply Envelope).
For each of the jobs 1 through 25 and Automatic an offset can be switched on or off
using the button.
In the case of offset “on” the last document that was added to the set will be shifted
from the rest of the set (offsetting). This document will be held back during a certain
distance. This means that the trailing edge of this upper document leaves the collator
at last. This document will not be folded. During the insertion into the envelope the
documents of the set will be realigned.
The conditions are:
- The feeder that supplies this upper document (BRE) is set to one document per
set (no multi feeding).
- The document directly beneath this document must be at least 60 mm (2.4 inch)
longer than the BRE.
- The upper document must be longer than the set address fold.
- The folding mode is either V-fold or C-fold (no Z-fold).
- The upper document must be shorter than the envelope height.
The whole BRE offset is based on friction between documents within a set.Therefore
it is necessary to make use of these conditions to reduce the risk of bad transporting,
folding and inserting.
It is possible to use the BRE offset for a BRE and an enclosure
(card) in one set.The extra condition is that this enclosure is equal
to or smaller than the set address fold and should be placed direct
underneath the BRE in the set.
3. Press the [Save] button to save the changes to the selected job.
6
En
glish
69
| Page 69 | jan-06-2012 13:58 |