Formax 6404 Series - Manual (Page 40)

Adjustment of the Document Stoppers
The document stoppers mark the position at which the documents coming from the feeder
turn towards the folding area. The position of the document stoppers is automatically
determined by the system during the job programming.
Initially the document stoppers are adjusted for position B. In this position a wide variety
of documents can be handled (max. 297 mm; 11.7 inch) and adjustment is not needed.
When a job is selected in which a different stopper position has been programmed, the
operator has to put the document stoppers in the correct position as indicated by the display.
To adjust the stopper position:
1.
Lift and hold the collator arm D.
2. Squeeze the stopper and pull the front side tab up.
3. Place the flat back tab into the correct slotted hole.
4. Push the stopper into position.
Stop position A can handle documents up to 148 mm (5.8 inch), stop position B can handle
documents up to 297 mm (11.7 inch) and stop position C can handle documents up to 356
mm (14 inch).
4
En
glish
33
| Page 33 | jan-06-2012 13:58 |