Formax 6404 Series - Manual (Page 30)

Adjusting the Production Feeder Document Separation
When the production feeder is used at an automatic separation feeder, the separation is set
automatically.
It can also be used on a feeder position with a manually adjusted separation.
To adjust, proceed as follows:
1. Remove the document feeder trays 2 and 3.
The lowest feeder is feeder 1.
2. Squeeze the two blue handles A and B and shift the feeding plate C as far as possible
to the front.
3. Push knob D forward until it clicks.
4. Place a document/BRE on the feeder tray and slide it in the system till the leading
edge is not visible anymore. Turn knob D counterclockwise if the separation is set to
narrow.
5. Push the document/BRE between the rollers.
6. Turn knob D clockwise to get more resistance and counterclockwise if the separation
is set to narrow.
The separation is adjusted correctly when a slight resistance is felt on the
document/BRE.
7. Pull knob D back when ready.
8. Replace the document feeder trays 2 and 3.
3
En
glish
23
| Page 23 | jan-06-2012 13:58 |