Formax 6404 Series - Manual (Page 74)

System Output
To change the output mode for a selected job:
1. Use the arrows next to "Select job" to select for which job (Job 1-25 or Auto) you want
to make the changes.
2. Use the next to Output to change the Output mode for the selected job.
Mode 1 focuses on the versatility of paper parameters (paper thickness; document
length), i.e. correct operation under even extreme paper conditions.
Mode 2 is the default mode, and focuses on high speed and is achieved as follows:
- During multi feed (more than one page from one feeder) the movement on the
collator is minimal. In mode 1 the divert unit will be used for completing the
collating process.
- During the transportation of a set from the collator into the powerFold, the next
set is going into the collator already. This results in temporary overlapping sets
with two different transport directions. In mode 1 the set has left the collator
completely before the next set enters the collator.
- Anticipation call for the envelope is used. That means that a (folded) set is
leaving the powerFold already before the envelope is ready on the insert position.
In mode 1 the envelope is on the insert position already before the set leaves
the powerFold.
It is advised to use Mode 1 with a paper thickness of 65 g/m2 or less, a document
length of 12 inch (305 mm) or higher, and for situations where Mode 2 is not functioning
properly. In all other cases Mode 2 is advised.
3. Use the next to BRE with window to select if the reply envelope has a window or
not.
This option is only available for Output mode 2.
4. Press the [Save] button to save the changes to the selected job.
6
En
glish
67
| Page 67 | jan-06-2012 13:58 |