Comtech EF Data CDD-56X Series Vipersat - Manual (Page 77)

Chapter 3 - Using the Command Line Interface (CLI) 3-43
MN/22137, rev 1 Vipersat Configuration
Enter K at the command prompt to configure this feature, as shown in
figure 3-56, below.
Figure 3-56 Vipersat Management Security screen
Enter M at the command prompt to toggle between Enabled/Disabled. Note that
the feature must be set to Enabled in order to configure the encryption key.
Enter K at the command prompt and Enter the required key (figure 3-57).
(Following entry, the characters will be temporarily displayed in the menu for
reference pruposes.)
Figure 3-57 Encryption Key Entry prompt
Enter V at the command prompt and re-enter the same key to Verify it.
(Following entry, the characters will be temporarily displayed in the menu for
reference purposes.)
Enter G at the command prompt to execute the verfication process and Gener-
ate the hex key.
The Future Key menu item will display Valid to indicate successful verification
of the key and that it is ready for activation.
Enter A at the command prompt to Activate the key for current use.
The Current Key menu item will display Valid to indicate successful activation.