Comtech EF Data CDD-56X Series Vipersat - Manual (Page 61)

Chapter 3 - Using the Command Line Interface (CLI) 3-27
MN/22137, rev 1 Vipersat Configuration
Figure 3-32 Delete Remote prompt
Enter the number of the Remote CDD-56X at the command prompt to delete it
from the STDMA group for this Hub burst controller.
Enable/Disable Remote
Enter E at the command prompt in figure 3-23 to display the dialog shown in
figure 3-33. The Remotes in the network are displayed, indicating whether each
is currently Enabled (E) or Disabled.
Figure 3-33 Enable/Disable Remote prompt
Enter the number of the Remote at the command prompt to toggle the Remote
from its current Enable/Disable configuration.
In the example screen shown above, both Remotes 1 and 2 are Enabled.
View Remote(s)
Entering V at the command prompt shown in figure 3-23 will display the listing
of Remote(s) that belong to the STDMA group for this Hub burst controller, and
their status, as shown in figure 3-34.
Figure 3-34 View Remote(s) screen