Comtech EF Data CDD-56X Series Vipersat - Manual (Page 39)

Chapter 3 - Using the Command Line Interface (CLI) 3-5
MN/22137, rev 1 Menu Descriptions
Feature Configuration
Figure 3-4 Feature Configuration screen
The Feature Configuration screen shown in figure 3-4 allows the Enabling
and Disabling of the major Vipersat CDD-56X features.
Use this screen to enable and disable Vipersat features such as:
• Vipersat STDMA — Burst mode operation
• Vipersat Auto Switching — Allows switching to SCPC mode
• Vipersat File Streamer — Rapid file transfers over satellite network
Note: These Vipersat features must be Enabled or Disabled using this menu.
They are not accessible from the Vipersat Configuration menu.
Vipersat Feature Codes
From the Feature Configuration menu, verify whether or not the Vipersat
Feature Codes are Available (appears as shown in figure 3-4). These codes are
entered prior to shipment from the factory; however, if the codes display as
Unavailable, they will have to be re-entered. To enter the FAST Feature code,
enter Y at the command prompt.
The Vipersat FAST Feature Codes can be entered as 20 hexidecimal digits at
the command prompt as shown in figure 3-5.
NOTE