Comtech EF Data CDD-56X Series Vipersat - Manual (Page 25)

Chapter 2 - Quick Start Configuration 2-3
MN/22137, rev 1 Initial Configuration
The procedure for setting the modem configuration to match the defined
network role is presented later in this Quick Start (“Set the Vipersat Configura-
tion” on page 2-10).
Refer to the section “Unit Role” on page 3-38, and the following section
“Expansion Unit”, for additional details on setting a CDD-56X’s network role.
Setting Vipersat CDD-56X Operating Parameters
The following is an example of using the CLI to bring a Vipersat CDD-56X
with factory default settings to the configuration which allows the Vipersat
functions to be accessible.
Set the Feature Configuration
The operating parameters that will be configured in the target CDD-56X are, in
part, determined by the role the CDD-56X is to fill in the network, as shown in
table 2-1 and table 2-2.
Use the following procedure to configure a CDD-56X to the network role it is to
fill in a Vipersat network.
1. From the Main Menu shown in figure 2-1, select the Administration
command by entering A at the command prompt.
Table 2-1 CDD-56X Network Roles and Functions
Demod
Role / Location Expansion 1 2 3 4
Hub No STDMA SCPC SCPC SCPC
Hub Yes SCPC SCPC SCPC SCPC
Remote Yes SCPC SCPC SCPC SCPC