Comtech EF Data CDD-56X Series Vipersat - Manual (Page 27)

Chapter 2 - Quick Start Configuration 2-5
MN/22137, rev 1 Initial Configuration
Figure 2-3 Feature Configuration screen
To enter the feature code, enter Y at the command prompt, then enter the 20
digit FAST Feature Code, as shown in figure 2-4.
Figure 2-4 FAST Feature Code dialog
Tip: The network administrator will have the FAST Feature codes. These are
generated and stored by the unit serial number for the target CDD-56X.
The target unit’s serial number can be found on the rear of the unit
chassis.
4. After entering the FAST Feature code, return to the Administration screen,
shown in figure 2-2, and ensure that the Working Mode is set to Router-
Vipersat.
If it is not, enter C and change the setting by selecting 4, as shown in
figure 2-5. The unit will reboot automatically in order to implement the
change for this setting.