Comtech EF Data CDD-56X Series Vipersat - Manual (Page 42)

Vipersat Configuration MN/22137, rev 1
3-8 Vipersat CDD-56X Series User Guide
Vipersat Configuration
Entering V at the prompt from the CDD-56X Main Menu shown in figure 3-1
displays the Vipersat Configuration menu shown in figure 3-6.
Figure 3-6 Vipersat Configuration screen (Hub)
This menu lists the available commands for configuring a Vipersat CDD-56X.
Note that for the Hub unit only, the command Primary Heart Beat is displayed
in the Vipersat Configuration screen. For the Remote unit only, the status of the
Home State Revert setting is displayed.
Each of these commands is explained in the following sections.
STDMA Mode
The STDMA Mode parameters for this CDD-56X are accessed by entering T at
the Vipersat Configuration screen command prompt.
The items in the STDMA menu will vary depending on the function the target
CDD-56X performs in the network (Hub or Remote) and the Hub Type that is
designated. The STDMA screen shown in figure 3-7 is from a CDD-56X serv-
ing as a Hub with STDMA in the network. The Hub Type is designated as
Fixed, in this example.
For comparison, the STDMA screen for a CDD-56X operating in SCPC mode
(either as a Hub expansion unit or as a Remote mesh unit) is shown in
figure 3-8. Note that some of the command items differ between these two
screens, and most of the items on the SCPC menu are information-only display..