Comtech EF Data CDD-56X Series Vipersat - Manual (Page 57)

Chapter 3 - Using the Command Line Interface (CLI) 3-23
MN/22137, rev 1 Vipersat Configuration
• R = Removed – This Remote is currently removed from the burstmap.
When displayed, this status indicates that the Hub has removed this remote
from the burstmap due to a communications fault.
• D = Disabled – This Remote is currently disabled and is not in the
burstmap.
This status will be displayed when a remote is manually disabled by the
operator or administrator.
• S = Switched – This Remote is currently switched into SCPC mode.
When displayed, this status indicates that the VMS has automatically
switched the remote out of the burstmap and into SCPC operation.
• H = Home State Revert – This Remote is not currently receiving burst
maps. When a remote, stuck in SCPC mode by failure to receive a VMS
revert command, sees the burst map with this flag set, it will automatically
revert to its home state and STDMA mode.
• CF – This Remote has not sent an acknowledgement to the burst controller
since it was enabled.
Most commonly, either a B or an S will be displayed, as a typical Remote
will be either Bursting or Switched out to the dSCPC pool.
Base
Entering a B at the command prompt in figure 3-23 allows entering the Remote
number to start displaying remotes in this menu screen. Entering the number 1,
as shown in figure 3-23, displays nine remotes, 1 through 9. If the number 4 had
been entered, the display would show the nine remotes starting with Remote 4
(i.e., remotes 4 through 12).
Figure 3-25 Base Remote Display prompt
Remote Count
The Remote Count menu item in figure 3-23 is an information-only display
showing the total number of Remotes that currently belong to the STDMA
group for this Hub burst controller.