Figure 3-2 administration screen, Figure 3-3 working mode dialog, N in figure 3-2 – Comtech EF Data CDD-56X Series Vipersat User Manual

Page 38

Menu Descriptions

MN/22137, rev 1

3-4

Vipersat CDD-56X Series User Guide

Figure 3-2 Administration screen

Ensure that the Working Mode is set to Router-Vipersat.

If it is not, enter C at the command prompt and change the setting by selecting

4, as shown in figure 3-3. The unit will reboot automatically in order to imple-

ment the change for this setting.

Figure 3-3 Working Mode dialog

Note: If the Router-Vipersat option does not appear as a selection, the Vipersat

Feature Code has not yet been entered into this unit. Input the Vipersat

code as described in the next section..

From the Administration menu, enter an F at the prompt to display the Feature

Configuration screen shown in figure 3-4.

NOTE