Comtech EF Data CDD-56X Series Vipersat - Manual (Page 41)

Chapter 3 - Using the Command Line Interface (CLI) 3-7
MN/22137, rev 1 Menu Descriptions
To activate the Vipersat Auto Switching capabilities of the target CDD-56X,
toggle the Auto Switching command to Enabled by entering W at the command
prompt.
See the section “STDMA/SCPC Automatic Switching” on page 3-32 for more
details on the use of this feature. For additional information, refer to Appendix
B, “Automatic Switching”.
Vipersat File Streamer
Vipersat File Streamer (VFS) is an optional feature that allows rapid file trans-
fers over the satellite network between host PCs that are running the client VFS
application. To activate the Vipersat File Streaming capabilities of the
CDD-56X, toggle this command to Enabled by entering R at the command
prompt.
Once the parameters on the Feature Configuration screen have been set as
desired, return to the Main Menu and enter the V command to display the
Vipersat Configuration screen shown in figure 3-6.