Comtech EF Data CDD-56X Series Vipersat - Manual (Page 54)

Vipersat Configuration MN/22137, rev 1
3-20 Vipersat CDD-56X Series User Guide
To change this setting, enter B at the command prompt to display the dialog
shown in figure 3-20.
Figure 3-20 Maximum Data Length prompt
Minimum Data Length
This menu item, which appears for Dynamic Slot, Dynamic Cycle, GIR, and
Entry Channel Hub types, displays the current Minimum Data Length in milli-
seconds and bytes for the remotes in the group, and represents the minimum
amount of data that can be transmitted or received in one spin of the STDMA
cycle by each of the remotes belonging to that group. This is the minimum
amount of time that the remote is provided to send data in the cycle.
Entering an M at the command prompt brings up the dialog shown in
figure 3-21 allowing the minimum data length, in milliseconds, to be changed
for the target CDD-56X.
Figure 3-21 Minimum Data Length prompt
Total Slot Count
This menu item appears for Hub units operating in ECMv2 only.