Comtech EF Data CPA - Manual (Page 66)

CPA C-Band Indoor Solid-State Power Amplifier Revision 1
Front Panel Operation MN/CPA-IN.IOM
5–10
To edit the SNMP Trap Community string: Use the ◄ ► arrow keys to first select the
character to edit, and then use the ▲▼ arrow keys to edit that character. Press
ENTER when done.
For the preceding menus, only the first 20 characters on the bottom line are
available. All printable ASCII characters are available with the exception of the
backslash (ASCII code 92) and ~ (ASCII code 126). Once you have composed the string
and pressed ENTER, all trailing spaces are removed from the Community string upon
entry.
If selecting CONFIG: REMOTE → Ethernet Config → SNMP → Traps:
SNMP Trap IP Address:
IP1 IP2 Version
Use the ◄ ► arrow keys to select IP1, IP2, or Version, and then press ENTER.
If selecting Ethernet Config: SNMP → Traps → SNMP Trap IP Address IP1 or IP2:
Trap IP #1:
000.000.000.000(◄ ► ▲ ▼ E)
Trap IP #2:
000.000.000.000(◄ ► ▲ ▼ E)
To edit the Trap Destination’s IP Addresses: Use the ◄ ► arrow keys to first select
the character to edit, and then use the ▲▼ arrow keys to edit that character. Press
ENTER when done.
If both Trap IP Addresses are 000.000.000.000, then it means that Traps
are disabled.
If selecting Ethernet Config: SNMP → Traps → SNMP Trap IP Address Version:
Trap Version:
SNMPv1 SNMPv2 (◄ ► E)
Use the ◄ ► arrow keys to select the trap version as SNMPv1 or SNMPv2, and
then press ENTER.