Comtech EF Data CPA - Manual (Page 13)

CPA C-Band Solid State Power Amplifier Revision 1
Preface MN/CPA-IN.IOM
xi
Recommended Standard Designations
The new designation of the Electronic Industries Association (EIA) supersedes Recommended
Standard (RS) designations. References to the old RS designations may be shown when depicting
actual text (e.g., RS-232) as displayed on the unit’s Web Server Interface pages or frontpanel
menus. All other references in the manual will be shown with the EIA designations.
Metric Conversion
Metric conversion information is located on the inside back cover of this manual. This
information is provided to assist the operator in cross-referencing non-Metric to Metric
conversions.
The user should carefully review the following information:
Safety and Compliance
Electromagnetic Compatibility (EMC) Compliance
Properly shielded cables for DATA I/O are required in order to meet the European
Electromagnetic Compatibility (EMC) Directive (EN55022, EN50082-1). More specifically,
these cables must be shielded from end-to-end, ensuring a continuous ground shield.
In accordance with European Directive 2004/108/EEC, the CPA family of products has been
shown, by independent testing, to comply with the following standards:
This product contains a Lithium Battery. DANGER OF EXPLOSION EXISTS if the battery
is incorrectly replaced. Replace only with the same or equivalent type recommended by
the manufacturer. Dispose of used batteries in accordance with local and national
regulations
This equipment has been des igned to minimize expos ure of pers onnel to hazards . The
operators and technicians mus t:
• Know how to work around, with, and on high voltage and high RF power level
equipment.
• Exercise every precaution to ensure personnel safety.
• Exercise extreme care when working near high voltages/high RF power level
equipment.
• Be familiar with the warnings presented in this manual.
• Disconnect the power supply cord before servicing the ISSPA.