Comtech EF Data KST-2000A/B - Manual (Page 54)

Ku-Band Satellite Transceiver Revision 9
Operation MN/KST2000AB.IOM
3–6
Step Procedure Remarks
8 Use the RFMC program a KP-10, or terminal
emulator, access unit A, enable backup operation in
manual mode using the remote commands listed in
Appendix B.6.
9 1. Using the backup manual operation command to
Unit A, place Unit A uplink and downlink online.
2. Ensure unit A reports that both its uplink and
downlink are on-line.
See Appendix B.6.
10 Perform the uplink setup steps listed in Section 3.1.1 Perform the downlink setup steps listed in Sec-
tion 3.1.2
11 1. Using the backup manual operation command to
Unit B, place Unit B uplink and downlink online.
2. Ensure that unit B reports its uplink and downlink
are both online.
See Appendix B.6.
12 Repeat step 14 for Unit B uplink. Repeat step 14 for Unit B downlink.
13 Turn the RF output of the up converters of Unit A and
B On. See Appendix B.3.
14 Execute a Reset Redundancy Fault command, to
Units A and B. See Appendix B.9.
15 1. At this point there should not be any existing
faults.
2. Execute a command to
clear the fault logs of Unit A and Unit B, wait a
few moments.
3. Execute a command to
Units A and B, and a common equipment stored
faults command to verify.
See Appendix B.9.
16 Remove AC power from Units A and B, remove the
70 MHz (140MHz) test source from RJU-2000 J12,
the RX signal source, and coupler/attenuator from the
TX switch.
17 1. The system is ready for final installation to the
antenna feed.
2. Perform the rest of the system alignment to
applicable international, national, or local stan-
dards.
Note: If the KP-10 is used to communicate with the RJU-2000, the user must manually enter the
transceiver address. Using the global address will create anomalies.