Comtech EF Data KST-2000A/B - Manual (Page 160)

Ku-Band Satellite Transceiver Revision 9
FSK Remote Control Commands MN/KST2000AB.IOM
E-8
Parameter
Type Command
(Instruction
Code and
qualifier) Arguments for
Command or
Response to
Query Description of arguments
(note that all arguments are ASCII numeric codes, that is, ASCII
codes between 48 and 57) Response to Command (target to
controller) Query
(Instruction
Code and
qualifier)
Reference
Frequency Adjust REF= 3 bytes Command or Query.
>add/REF=’cr’’lf’
>add/REF=nnn’cr’’lf’
Where: nnn = 000 to 255 REF= (message ok)
REF? (received ok, but invalid arguments
found)
REF* (message ok, but not permitted in
current mode) REF?
Set Physical
Address SPA= 3 bytes Command or Query.
>add/SPA=’cr’’lf’
>add/SPA=xxx’cr’’lf’
Where: xxx = new address SPA= (message ok)
SPA? (received ok, but invalid argument
found)
SPA* (message ok, but not permitted in
current mode) SPA?
LNA Calibrated CAL= None Command only.
>add/CAL=’cr’’lf’
Calibration to allow system to determine nominal LNA power
consumption, performed at initial installation only.
Note: Not applicable for a TX only system CAL= (message ok)
CAL? (received ok, but invalid argument
found)
CAL* (message ok, but not permitted in
current mode) n.a.
LNA Power
Enable LCS= 1 byte Command or Query.
>add/LCS=’cr’’lf’
>add/LCS=x’cr’’lf’
Where: x = 0 (Off)
1 (On) LCS= (message ok)
LCS? (received ok, but invalid argument
found)
LCS* (message ok, but not permitted in
current mode) LCS?
LNA Fault
Enable LFL= 1 byte Command or Query.
>add/LFL=’cr’’lf’ LFL= (message ok)
LFL? (received ok, but invalid argument
found) LFL?