Comtech EF Data KST-2000A/B - Manual (Page 134)

Ku-Band Satellite Transceiver Revision 9
Single-Thread Equipment Mounting MN/KST2000AB.IOM
C–8
4. Position two spring nuts in each of the Unistrut channels mounted to the
converter. Position these nuts between the pipe blocks and the ends of the
Unistrut.
Above the spring nuts, position the flat fitting plates with the locating notches
engaged in the openings of the channels.
5. Thread a 5/16” nut, split and flat washer onto each of the threaded rods, leaving
1” of rod remaining. Thread that end of the rod through the flat fitting plates and
fully into the spring nuts (do not bottom out).
Using one of the mating channels, ensure that the threaded rods from the
channels mounted to the converters are aligned with holes in the mating
channels. Center these rods with the channels as well as possible and tighten the
hardware.
6. Thread a 5/16” nut, split, flat washer and flat fitting plate on the remaining ends
of the threaded rods. This hardware is to secure the mating Unistrut channels
from the opposite side of the pole to the threaded rod. Adjust accordingly.
7. Position the converter assembly with the pipe blocks against the pole (refer to
Figure C-4), slide the mating Unistrut channels onto the threaded rods from the
opposite side (pipe blocks against pole and channels against flat fitting plates).
Adjust and fasten with the
5/16” hardware (4 each flat, split washers and nuts).
Figure C-4. Rear View of Converter Installed on
Round Pole