Comtech EF Data KST-2000A/B - Manual (Page 111)

B–1
Appendix B. TERMINAL MODE
COMMANDS
This appendix defines the protocol and command structure for remote control and status
monitoring of the KST-2000A/B in the terminal mode of the Windows™ based M&C
remote control software and on the KP-10 keypad.
• Firmware number: FW/10303-1D
• Software version: 1.1.5
B.1 General
The commands for Firmware 10303-1 are listed in this manual. The following table show
evolution of the firmware. Contact Comtech EF Data, Customer Support Department, if
there is a problem or concern regarding the firmware.
Firmware Revision Version Remarks
7084-1 K 2.1.1 No FSK and Keypad
9364-1 D 3.1.1 FSK and No Keypad
10303-1 D 1.1.5 FSK and Keypad
Remote control and status information are transferred via an EIA-485, EIA-422 or
EIA-232 serial communications link. Commands and data are transferred on the remote
control communications link as ASCII encoded character strings. The remote
communications link is operated in a half duplex mode. Communications on the remote
link are initiated by a remote controller or terminal. The KST-2000A/B never transmits
data on the link unless it is commanded to do so.