Comtech EF Data KST-2000A/B - Manual (Page 37)

Ku-Band Satellite Transceiver Revision 9
Installation MN/KST2000AB.IOM
2–9
2.4.1.6 RX MON Connector (J5)
The RX MON connector (J5) provides the received (downlink) signal at L-Band (950 to
1700 MHz) for monitoring. This signal has a gain of 20 dB relative to the carrier.
Connector J5 is a Type N, female connector. Nominal output impedance is 50
Ω.
Parameter Frequency Frequency Frequency
Ku-Band Frequency, GHz 10.95 to
11.699
11.70 to
12.249
12.25 to
12.75
Subtract the DRO Frequency,
GHz –10.0 –10.75 –11.3
RX MON at L-Band, MHz 950 to 1699 950 to 1499 950 to 1450
2.4.1.7 RF OUT Connector (J6)
The RF OUT connector (J6) is a type N, female, 50
Ω connector used to connect the
converter unit’s output at Ku-Band (uplink) to an HPA. Power output at 1 dB
compression is +15 dBm minimum.
2.4.1.8 RF IN Connector (J7)
The RF IN connector (J7) is a type N, female, 50
Ω connector used to connect the LNA’s
output at Ku-Band (downlink) to the converter unit for the KST-2000A. This same
connector is used to connect the LNB's output at L-Band to the converter unit for the
KST-2000B.