Comtech EF Data KST-2000A/B - Manual (Page 167)

Ku-Band Satellite Transceiver Revision 9
FSK Remote Control Commands MN/KST2000AB.IOM
E-15
Parameter
Type Command
(Instruction
Code and
qualifier) Arguments for
Command or
Response to
Query Description of arguments
(note that all arguments are ASCII numeric codes, that is, ASCII
codes between 48 and 57) Response to Command (target to
controller) Query
(Instruction
Code and
qualifier)
Circuit
Identification
(CID) CID= 24 bytes Command or Query.
>add/CID=’cr’’lf
>add/CID=abcdefghijklmnopqrstuvwx’cr’’lf’
Note: The CID shall contain 24 characters. Valid characters include:
Space ( ) * + = , . / 0-9 A-Z CID= (message ok)
CID? (received ok,
but invalid argument found)
CID* (message ok, but not permitted in
current mode) CID?
Firmware
Numbers n.a. 52 bytes Query only.
>add/FRW=aaaaaaabbbbbbcccccccddddddeeeeeeeffffffggggggghhh
hhh’cr’’lf’
Where: aaaaaaa=M&C FW # with dash and rev (eg. 7084-1G)*
bbbbbb=M&C FW # version
(eg. 010012 for 01.00.12)
ccccccc=Up converter FW # with dash and rev*
dddddd=Up converter FW # version
eeeeeee=Down converter FW #with dash and rev*
ffffff=Down converter FW #version
ggggggg=HPA FW # with dash and rev*
hhhhhh =HPA FW #version
Firmware numbers have exceed 999-1X.
• Numbers 0000 to 6999 shall be decoded as 10000 to
16999.
• Numbers 7000 to 9999 are decoded as is.
FRW= (message ok)
FRW? (received ok, but invalid arguments
found)
FRW* (message ok, but not permitted in
current mode) FRW?
Assembly
Numbers n.a. 28 bytes Query only.
>add/ANM=aaaaaaabbbbbbbcccccccddddddd’cr’’lf’
ANM= (message ok)
ANM? (received ok, but invalid arguments
found)
ANM* (message ok, but not permitted in
current mode) ANM?