Comtech EF Data KST-2000A/B - Manual (Page 159)

Ku-Band Satellite Transceiver Revision 9
FSK Remote Control Commands MN/KST2000AB.IOM
E-7
Parameter
Type Command
(Instruction
Code and
qualifier) Arguments for
Command or
Response to
Query Description of arguments
(note that all arguments are ASCII numeric codes, that is,
ASCII codes between 48 and 57) Response to Command (target to
controller) Query
(Instruction
Code and
qualifier)
Up Converter
Frequency UFQ= 7 bytes Command or Query.
>add/UFQ=’cr’’lf’
>add/UFQ=nnnnn.n’cr’’lf’
Where: nnnnn.n = 13750.0 to 14500.0 MHz, in 1 MHz steps UFQ= (message ok)
UFQ? (received ok, but invalid arguments
found)
UFQ* (message ok, but not permitted in
current mode) UFQ?
Down Converter
Frequency DFQ= 7 bytes Command or Query.
>add/DFQ=’cr’’lf’
>add/DFQ=nnnnn.n’cr’’lf’
Where: nnnnn.n = 10950.0 to 12750.0 MHz, in 1 MHz steps DFQ= (message ok)
DFQ? (received ok, but invalid arguments
found)
DFQ* (message ok, but not permitted in
current mode) DFQ?
Up Converter
Attenuation UAT= 4 bytes Command or Query.
>add/UAT=’cr’’lf’
>add/UAT=nn.n’cr’’lf’
Where: nn.n = 00.0 to 20.0 dB, in 1.0 dB steps UAT= (message ok)
UAT? (received ok, but invalid argument
found)
UAT* (message ok, but not permitted in
current mode) UAT?
Down Converter
Attenuation DAT= 4 bytes Command or Query.
>add/DAT=’cr’’lf’
>add/DAT=nn.n’cr’’lf’
Where: nn.n = 00.0 to 10.0 dB, in 1.0 dB steps DAT= (message ok)
DAT? (received ok, but invalid arguments
found)
DAT* (message ok, but not permitted in
current mode) DAT?