Comtech EF Data KST-2000A/B - Manual (Page 137)

Ku-Band Satellite Transceiver Revision 9
Single-Thread Equipment Mounting MN/KST2000AB.IOM
C–11
b) For PRODELIN offset antennas with long feed supports:
Attach the appropriate interface bracket from below the feed support using
the existing hole near the end of the feed support. Fasten, using the 1/4”
hardware (1" bolt, flat, split washer and nut).
c) For Channel Master antenna:
Attach the interface bracket from below the feed support with the 5/16"
hardware and nut plate.
5. Apply the scale overlay to the outward-facing side of the SSPA "U" bracket. See
Note: Either side of the U bracket may face out, depending on the requirements
of a particular installation.
6. Slide the SSPA "U" bracket horizontally between the tabs of the interface
bracket. Lift and guide the "U" bracket up onto the SSPA while tightening the
hardware under the interface bracket. Refer to Figure C-6. Installing the SSPA
Figure C-6. Installing the SSPA