Avery Dennison ALX 720 - Manual (Page 86)

Operators Manual
ALX 720
4/09 Page 86 Status messages
Problem Meaning How to solve
ST05 Material end Depress NEXT key to switch off acoustic
signal
Depress (FEED) key to acknowledge
status message Display:
“OFF“
Insert material, check and, in case,
correct light barrier position
(ON/OFF) key - job is further processed
gap is re-initialised
ST06 Print head overheating Integrate printing breaks. Lower TEMP.
Check HRES
ST07 Foil end WITH THERMAL PRINT
Make sure that program point „FMOD“ is
set to „NO“
WITH THERMAL-TRANSFER PRINT
Tighten foil resp. adjust spring blade at
foil unwind gudgeon that the foil is
drawing the gudgeon and the foils paper
core can be still removed
Depress (FEED) key to acknowledge
status message display: “OFF“
(ON/OFF) key - job is further processed
gap is re-initialised
Depress (NEXT) key to switch off
acoustic signal
Depress (FEED) key to acknowledge
status message display: “OFF“ - insert
foil
(ON/OFF) key - job is further processed
gap is re-initialised
ST08 No gap detected or 3 or more
labels missing Check print mask for gap definition
Make sure that correct material is
inserted
Make sure that light barrier is clean
Check material guide and light barrier
position
(ON/OFF) key -job is further processed
gap is re-initialised Media is not moving
into media sensor (infeed)
media to short