Avery Dennison ALX 720 - Manual (Page 28)

Operators Manual
ALX 720
4/09 Page 28 Operation
y
Switch printer to OFFLINE mode and lift print head by brief pressing of the FEED key. Open
front cover.
y
Hang document material in reel holder in a way to ensure unwinding that label in the printer
section is on the top. Put outer guide disk onto mandrel. The 2 guide plates keep the label
roll reliably in position on the unwind mandrel.
y
Guide material around the dancer arm.
y
Press the red lift lever at the right, outer end of the print module in order to lift the pressure
rolls of the feed roller and insert material below the print head. Adjust both pressure roll
units symmetric to material width so that material moves smoothly.
y
Labels behind the dispensing edge should be removed. The material brush has to be
positioned in a way, that the material is kept tight. From time to time it is recommended to
reverse the mounting of the brush while you are loading a new label roll.
y
Adjust the pressure roller before the rewind, so that it is right in the middle of the material.
Close the pressure roll and turn the roll 2 or 3 times, so that the material is threaded. Check
that the material is guided straight.