Avery Dennison ALX 720 - Manual (Page 65)

Operators Manual
ALX 720
4/09 Page 65 Printer adjustment
6.3 PRTP: Print parameter adjustments
In this submenu the adjustment of the print function is possible.
Print Speed ______________________________________________________PSPD
The printing speed (material feed) can be adapted to the foil/material combination used to
optimise contrast intensity and imprint density of the print.
„PS.4“
4 inches/second; ditto for 5-12 inches per second.
Material Length _________________________________________________ MLEN
Material length (gap distance - measured from the beginning of one label to the beginning of
the next one) can be altered in mm-steps. The recognised gap position corresponds to the
beginning of the label.
If sending a label format the value will be overwritten by the corresponding Easy Plug
command.
„L..5“
Minimum length 5 mm
„ LXXX“ Maximum length 330 mm (depending on print head width and spooler
configuration, see also printout:(STAO)
Material Width __________________________________________________ MWID
Position of the left edge can be altered in mm-steps if printer is in the line printer mode.
If sending a label format the value will be overwritten by the corresponding Easy Plug
command.
„W.25“
Minimum width 25 mm
„WXXX“ Maximum width 107 mm
GAP Offset _____________________________________________________ PUNO
The 0-position can be determined offset from the recognised gap position in mm-steps.
If sending a label format the value will be overwritten by the corresponding Easy Plug
command.
„.-15“ Maximum (negative) offset in feed direction
„+300“
Minimum (positive) offset against feed direction