AMETEK SLM Series RevC - Manual (Page 83)

Sorensen SLM-Series DC Load Remote Programming
M540071-01 Rev C 5-27
CURRENT Limit
Purpose:
To read the set value of upper/lower limit value of threshold current.
Command Syntax:
All Modules:
LIM:CURR{HIGH|LOW}?{;|NL}
Description:
LIM:CURR:LOW? Reads back the lower limit set value of threshold current; unit is
“amps (A)”.
POWER Limit
Purpose:
To read the set value of upper/lower limit value of threshold power(W).
Command Syntax:
SLM DC Modules:
LIM:POW{HIGH|LOW}?{;|NL}
Description:
LIM:POW:LOW? Reads back the lower limit set value of threshold power; unit is “watts” (W).
VA Limit
Purpose:
To read the set value of upper/lower limit value of threshold power (VA).
Command Syntax:
SLM AC Modules:
LIM:VA{HIGH|LOW}?{;|NL}
Description:
LIM:VA:LOW? Reads back the lower limit set value of threshold power, unit is (VA).
NG
Purpose:
To read the set value of NG.
Command Syntax:
All Modules:
NG?{;|NL}
Description:
NG? Reads back the condition indicating light of NG. “0” denotes that NG (NO GOOD) indicating
light has been extinguished. “1” denotes that NG indicating light has been lit.
NG Enable /Disable
Purpose:
To read NG ON/OFF setting.
Command Syntax:
SLD Modules:
NGAB{?}{;|NL}
Description:
NGAB? returns the presently NG ON/OFF status, “0” indicates NG disable, and “1” indicates NG
enable.
PERIOD
Purpose: