AMETEK SLM Series RevC - Manual (Page 63)

Sorensen SLM-Series DC Load Remote Programming
M540071-01 Rev C 5-7
REMARKS:
1. d : 0 - 9
2. GLOB : GLOBAL (ALL CHANNELS ACTIVE AT SAME TIME)
3. CURRENT ENGINEERING UNIT : A
4. VOLTAGE ENGINEERING UNIT : V
5. RESISTANCE ENGINEERING UNIT :
Ω
6. PERIOD ENGINEERING UNIT : mS
7. SLEW-RATE ENGINEERING UNIT : A/
μS
Note
: The RS-232 command set is the same as the GPIB command set.
5.4 GPIB/RS-232 Command Description
5.4.1 Setting Commands
CHANNEL
Purpose:
”CHAN＂ selects the multiple Electronic load channel to which all subsequent channel-specific
commands will be directed.
Command Syntax:
All Modules:
CHAN{SP}n{;NL}
Description:
”CHAN＂ command selects the specified Electronic load module from 1 through 4 as the Electronic
load module number (from left to right). Up to 4 channels of the Electronic load module can be
installed in one mainframe. This command is a channel independent command; therefore, this
command should be programmed before an electronic load channel dependent command.
The load channel number is arranged as 1, 2, 3, 4 from left side to the right side. Module SLD-60-
105-550 is a dual bay module that utilizes the channel number corresponding to the bay occupied
by the right side of the module. E.g., if a dual bay module takes up bays 1 and 2, its channel
number shall be 2.
Example:
CHAN 2 select channel 2 of SL-series mainframe.
Note:
Please refer to Appendices C, D and E for proper programming procedure of SL-series electronic load
modules.
CURRENT Level
Purpose:
The load current setting in Constant Current mode.
Command Syntax:
All SLM Modules:
CC:{LOW|HIGH}{SP}{NR2}{;|NL}
SLD Modules: CC{SP}{NR2}{;|NL}