AMETEK SLM Series RevC - Manual (Page 34)

Operation Sorensen SLM-Series DC Load
3-6 M540071-01 Rev C
rating of each SLM-series DC load module and the connection method utilized (see
Section 2.2.1).
Also check the polarity of DC input connection before testing.
18 V SENSE
Measures the specific voltage points through the V-sense BNC - CLIP cable.
NOTE: Avoid High Voltage Hazards - refer to Section 2.2.2 for cautions and warnings about
connections.
19 I MONITOR
Sends the load current waveform output to an oscilloscope to evaluate the current waveform
of a power supply under test.
See Section 1 for voltage/current relationship of I-Monitor outputs in SLM-series DC series
modules.
3.1.2 Summary Chart
The front panel controls are summarized in Figure 3-2.
CC: Constant Current
CR: Constant Resistance
CV: Constant Voltage
CP: Constant Power
MODE (3)
PRESET
DWM/DAM Display
DVM/DAM
PRESet (7)
G/NG Volt Limits
G/NG Curr. Limits
G/NG Power Limits
AUTO
ON
Vsense
Load On Voltage
Load Off Voltage
AUTO
Rang II
Range
iStart
iStop
iStep
PStart
PStop
Pstep
Vthreshold
Normal
OCP
OPP
Test
LIMIT (12)
HI
LO
LEVEL (9)
ON
OFF
LOAD (8)
DYNamic
STAtic
DYN/STA (10)
ON
OFF
SHORT (11)
SLM DC Loads
Button Functions
Figure 3-2 Organization of Front Panel Controls of SLM-Series DC Plug-in Module