AMETEK SLM Series RevC - Manual (Page 82)

Remote Programming Sorensen SLM-Series DC Load
5-26 M540071-01 Rev C
All Modules: SENS?{;|NL}
Description:
SENS? Reads back the setting condition of SENS. “0” denotes OFF, “1” denotes ON.
WATT Meter ON/OFF
Purpose:
To read the setting condition of WATT.
Command Syntax:
SLM Modules:
WATT?{;|NL}
Description:
WATT? Reads back the setting condition of WATT. “0” denotes OFF, “1” denotes ON.
WAVEFORM BANK
Purpose:
To read the set value of BANK
Command Syntax:
SLM AC Modules:
BANK?{;|NL}
Description:
BANK? Reads back the set value of BANK. 0-10 denotes waveform bank of level 0-10.
WAVEFORM
Purpose:
To read the set value of WAVE.
Command Syntax:
SLM AC Modules:
WAVE?{;|NL}
Description:
WAVE? Reads back the set value of WAVE. 1-5 denotes the C.F. setting of level 1-level 5.
FREQUENCY
Purpose:
To read the set frequency of FREQ.
Command Syntax:
SLM AC Modules:
FREQ?{;|NL}
Description:
Reads back the set frequency of FREQ, unit is Hz.
VOLTAGE Limit
Purpose:
To read the set value of upper/lower limit value of threshold voltage.
Command Syntax:
All Modules:
LIM:VOLT:{HIGH/LOW}?{;|NL}
Description:
LIM:VOLT:LOW? Reads back the lower limit set value of threshold voltag;, unit is “volts" (V).