2 date and time – AGI Security SYS-HC0451 HDCVI DVR User Manual User Manual
Page 236

HDCVI Standalone DVR User’s Manual
227
HDD full
Here is for you to select working mode when hard disk is full. There
are two options: stop recording or rewrite. If current working HDD is
overwritten or the current HDD is full while the next HDD is no empty,
then system stops recording, If the current HDD is full and then next
HDD is not empty, then system overwrites the previous files.
Pack mode
It is for you to specify record duration. There are two modes: Time
length/File length.
Time length: It is to pack according to time length. The value
ranges from 1 to 60 minutes. Default value is 60 minutes.
File length: It is to pack according to file length. The value ranges
from 128M to 2048M. Default value is 1024M.
5.8.5.1.2 Date and time
The date and time interface is shown as in Figure 5-87
Figure 5-87
Please refer to the following sheet for detailed information.
Parameter Function
Date format Here you can select date format from the dropdown list.
Time
Format
There are two options: 24-H and 12-H.
Time zone
The time zone of the device.
System
time
It is to set system time. It becomes valid after you set.
Sync PC
You can click this button to save the system time as your PC current
time.
DST
Here you can set day night save time begin time and end time. You
can set according to the date format or according to the week format.
NTP
You can check the box to enable NTP function.
NTP server You can set the time server address.
Port
It is to set the time server port.