AGI Security SYS-HC0451 HDCVI DVR User Manual - Manual (Page 170)

HDCVI Standalone DVR User’s Manual
161
 On the navigation bar, click or to enable/disable tour function.
Figure 4-144
4.10.5.2.4 Zero-channel Encoding
Click zero-channel encoding button, you can go to the following interface. See Figure
4-145. Here you can enable and set zero-channel encoding function so that you can view
several video sources at one channel.
 Enable: This function is disabled by default. Check the box here to enable this
function so that you can control the zero-channel encoding function at the WEB.
 Compression: System default setup is H.264. You can set according to device
capability.
 Resolution: The resolution value may vary due to different device capabilities. Please
select from the dropdown list.
 Frame rate: The frame rate value may vary due to different device capabilities.
Please select from the dropdown list.
 Bit Rate: The bit rate value may vary due to different device capabilities and frame
rate setups. Please select from the dropdown list.
 Save: Click the Save button to save current setup. If this function is disabled, you can
not operate zero-channel encoding function at the WEB, the video is black or null
even you operate when the function is disabled. After you enabled this function, login