AGI Security SYS-HC0451 HDCVI DVR User Manual - Manual (Page 220)

HDCVI Standalone DVR User’s Manual
211
Parameter Function
message screen if you enabled this function.
Buzzer Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
Alarm upload System can upload the alarm signal to the centre (Including alarm
centre.
Message When 3G network connection is OK, system can send out a
message when motion detect occurs.
Send Email If you enabled this function, System can send out an email to alert
you when an alarm occurs.
PTZ
Activation Here you can set PTZ movement when an alarm occurs. Such as
go to preset X. See Figure 5-56.
Tour You need to check the box here to enable this function. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs. See Figure
5-57.
Snapshot You need to check the box here to enable this function. You can
set corresponding channel to snapshot when motion detect alarm
occurs. See Figure 5-58.
Video Matrix This function is for motion detect only. Check the box here to
enable video matrix function. Right now system supports
one-channel tour function. System takes
“first come and first
serve ” principle to deal with the activated tour. System will process
the new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
Log Check the box here, system can record motion detect event log.
5.8.3.1.2 Video Loss
The video loss interface is shown as in Figure 5-59.
After analysis video, system can generate a video loss alarm when the detected moving
signal reached the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest
setups, please refer to chapter 5.8.3.1.1 motion detect for detailed information.