beautypg.com

2 net alarm – AGI Security SYS-HC0451 HDCVI DVR User Manual User Manual

Page 225

background image

HDCVI Standalone DVR User’s Manual

216

Parameter

Function

There are six periods in one day. Please draw a circle to
enable corresponding period.

Select date. If you do not select, current setup applies to
today only. You can select all week column to apply to the
whole week.

Click OK button, system goes back to local alarm
interface, please click save button to exit.

Anti-dither

System only memorizes one event during the anti-dither
period. The value ranges from 5s to 600s.

Sensor type

There are two options: NO/NC.

Record channel

System auto activates motion detection channel(s) to
record once an alarm occurs. Please note you need to set
alarm record period and go to Storage-> Schedule to set
current channel as schedule record.

Record Delay

System can delay the record for specified time after alarm
ended. The value ranges from 10s to 300s.

Alarm out

Enable alarm activation function. You need to select alarm
output port so that system can activate corresponding
alarm device when an alarm occurs.

Latch

System can delay the alarm output for specified time after
an alarm ended. The value ranges from 1s to 300s.

Show message

System can pop up a message to alarm you in the local
host screen if you enabled this function.

Buzzer

Check the box here to enable this function. The buzzer
beeps when an alarm occurs.

Alarm upload

System can upload the alarm signal to the centre
(Including alarm centre).

Send Email

If you enabled this function, System can send out an email
to alert you when an alarm occurs.

PTZ Activation

Here you can set PTZ movement when an alarm occurs.
Such as go to preset X. See Figure 5-65.

Tour

You need to check the box here to enable this function.
System begins 1-wiindow or multiple-window tour display
among the channel(s) you set to record when an alarm
occurs. See Figure 5-66.

Snapshot

You need to check the box here to enable this function.
You can set corresponding channel to snapshot when
motion detect alarm occurs. See Figure 5-67.

Log

Check the box here, system can record motion detect
event log.

5.8.3.2.2 Net Alarm

The network alarm interface is shown as in Figure 5-68.

Network alarm refers to the alarm signal from the network. System does not anti-dither

This manual is related to the following products: