AGI Security SYS-HC0451 HDCVI DVR User Manual - Manual (Page 195)

HDCVI Standalone DVR User’s Manual
186
Parameter Function
Delete
Click , you can delete the remote connection of the corresponding
channel.
Connection
status : Connection succeeded.
: Connection failed.
Delete Select a device in the Added device list and then click Delete button,
system can disconnect the device and remove it from the Added
device list.
Manual
Add
Click it, the interface is shown as in Figure 5-17. Here you can add
network camera manually.
You can select a channel from the dropdown list (Here only shows
disconnection channel.)
Note:
 System supports manufactures such as Panasonic, Sony,
Dynacolor, Samsung, AXIS, Arecont, Dahua and Onvif standard
protocol.
 If you do not input IP address here. System uses default IP
192.168.0.0 and system does not connect to this IP.
 Can not add two devices at the same time. Click OK button here,
system only connect to the corresponding device of current
channel.
5.8.1.2 Conditions
Here you can view device property information. The setups become valid immediately
after you set. See Figure 5-18(analog channel) and Figure 5-19 .
Figure 5-18