Junger Audio D*AP8 Digital Audio Processor - Manual (Page 83)

D*AP8
81
"Empty"
Creates a set of empty boxes where you may select the preset of
your choice for the respective function block or leave it empty if no
changes are needed …
Include these Blocks: [System / Interface / Routing / Dolby Processing /Audio Processor
>Programs / >AUX / >Delay / >Monitor / Measurement]. You can tell
the event manager which function blocks must be included in this
event (or not).
Important Note! This is the way to create your own snap shot . The new presets will be automatically
given the name of this event! So be careful to select meaningful names. You will find them later on in your
function blocks!
Setup GUI – EVENTS – Events – Parameter Events
Right now the D*AP8 supports parameter events to remote control the measurement / logging related
features of the J*AM:
The above example selects the category "Measurement" with its sub category "Loudness".
From the list of possible parameters, the setting of a marker "J*AM Marker – Program 1" has been
selected. This marker will appear in the log file if that preset event is executed. When you press
these choices are provided:
Event Name your choice
Use settings from [Existing Event / Defaults /
Empty]
Setup GUI – EVENTS – Events – Measurement Events
A measurement event is used to control the D*AP8 internal loudness meter.
(See MEASUREMENT > Loudness). For the example below "Reset" has been pre-selected for all
possible program configurations and their respective programs: