Junger Audio D*AP8 Digital Audio Processor - Manual (Page 25)

D*AP8
23
Setup GUI – SYSTEM – Firmware Update
The file to update the D*AP8 comes in ZIP format. You must unpack it to your PC's hard drive.
It contains also the manual a quick start guide the version history and a folder with the firmware for the
X*AP remote panel. The folder /base_unit_image contains the so called "image" file for the D*AP8. Here
an example: "rel_dap8_mei_1_2_3-45678.img". It is a bundle that brings the latest firmware versions for all
interfaces and Dolby modules with it.
To update the D*AP8, you must to find the respective firmware file (which you have
unzipped before) and press . If you do not want to upload all individual module firmware
files for any reason, you may take the "rel_dap8_mei_1_2_3-basic-45678.img" file.
After finishing the update the device will automatically reboot.
Important Note! After the update of the latest firmware image you must observe the Status messages
below the firmware version displays in the middle. If it indicates that you don't have the latest firmware
installed you should select the respective file via the drop down box and press the soft
button afterwards. But you can also upload an external file in case you need a specialized version for any
reason that is not contained in the uploaded firmware image. Same applies to all interface boards and the
Dolby OEM boards. See Interface 1 as an example: