Junger Audio D*AP8 Digital Audio Processor - Manual (Page 26)

D*AP8
24
Interface 1
You may also update the firmware of an optionally installed SDI board
or other interface boards.
Firmware Display of actual installed firmware.
Status [The latest firmware is installed / A firmware update is available]
Update Firmware [Load External File / x.y.z.]
You can decide if you want to upload it manually or take the latest
module firmware "x.y.z" that came with the release image
(recommended). You may the file system and select a file
of your choice.
Interface 2 If you have two interface boards installed, similar applies to the second
one.
Dolby Decoder / E-Encoder
For the example above we have the optional Dolby decoder installed.
(CAT1100) It is based on the Dolby OEM board CAT1100.
The status says: "The latest firmware is installed".
Pressing this soft button will warm start that module.
(cat1100)>
Dolby D Encoder (CAT561)
For the example above we have installed the optional Dolby E encoder.
It is based on the Dolby OEM module CAT559.
Pressing this soft button will warm start that module - depending
(cat561)> on the Dolby module you may have installed.
Licensing
Here you can see a list of the licensed options of your device.
When you buy a license you must provide the "license info" file which
you may obtain here.
Load License File
In return you will get a "license" file which you must apply to the device
here. You must to find the respective license file (which
you have unzipped before) and press .
Setup GUI – SYSTEM – Reboot
Restore Factory defaults Will clean up the parameter and preset memory and will initialize all
parameters to their factory default values and will reset passwords
and turn authentication off.
Overwrite Current IP You may exclude the current IP settings from this process
IP Configuration to keep your existing settings.