Junger Audio D*AP8 Digital Audio Processor - Manual (Page 30)

D*AP8
28
You must use the scroll bar to navigate through the matrix. In the upper left corner you can select between
the ONAIR and the PRESETS view of the matrix.
On the ON AIR page you will also see the device signal labels (see ROUTING section further below for
details).
Channel Linking [mono / stereo]
You can decide if the routing must be performed in mono or stereo mode
(where adjacent odd/even channels are routed at once).
You may select cross points by hovering with the mouse over the little squares and select / deselect cross
points with a left mouse button click. A trace that symbolizes the signal flow is shown.
The color of the respective squares changes:
Mouse over Color codes of cross points:
dark blue Possible new cross point.
orange You are about to reconnect a cross point.
grey Cross point is not allowed (i.e. routing will cause a loop and will not
therefore be performed) or dedicated input is not activated.
red You are about to disable a cross point
An animated signal flow will help you when navigating through the matrix.
Setup GUI – INTERFACES – SDI I/O interface – Setup
SDI Bypass
SDI Relay Bypass Will deactivate the Bypass
Relay. It provides a shortcut from
SDI-IN to SDI-OUT1 and
disconnects the de-embedder
from the SDI input. This relay
also serves as a fail bypass if
the power is off. This feature
maintains the SDI signal for
downstream equipment.
SDI Embedder Will pass the embedded audio
Bypass data from the de-embedder to the
embedder 1:1. This function
preserves the original
Ancillary Data structure.
Video Delay
Video Delay [0 … 15]
(frames) For compensation of any kind of
audio processing delay within the
chain of devices you may use a
Video Delay. Position “0” turns
off the delay function.