Junger Audio D*AP8 Digital Audio Processor - Manual (Page 37)

D*AP8
35
Setup GUI – INTERFACES – Dante I/O Interface – Inputs
The DanteController software gives you an overview of all members of such a Dante network.
You can assign channel labels for the inputs (from the network to the device interface). Those labels will
automatically appear in the D*AP8 and will be displayed there.
Here is a glimpse on the GUI of the DanteController:
As an example you see here a "DAP8-LM" (name given by the DanteController) that has assigned the
labels DAP8-LM 2/1 … 2/16 for the inputs and DAP8-LM 2/1/1 … 2/1/16 for the outputs.
For the outputs you can assign up to 16 different labels used for multi layer routing.
Beside a few more devices on that network, we see the unfolded outputs of a DanteVirtualSoundcard
(VSC) named "VSC-MARTIN" on the upper right hand side. The top horizontal area shows the
transmitters while the receivers are shown vertically on the left hand side.
The outputs PCM 1 … PCM 4 from the VCS are assigned to the D*AP8 inputs DAP8-LM 2/1 … 2/4
while four outputs DAP-8 LM 2/1/1 … 2/1/4 are assigned to the VSC inputs 01 … 04.