Doremi MCSHD - Manual (Page 65)

12.2.2 Recording the Video-Part
The audio should be recorded with the Video-part:
 Select “A Time” in the Time Code Mode menu (MENU (02)).
 Press the REC button only to set the V1-HD in EE mode. (Displays the video on the input).
 If you see a valid video signal on your monitor, press REC and PLAY at the same time to
start recording. The time-code will start incrementing one the V1-HD is in record.
 Press STOP to finish the recording the Video-part.
12.2.3 Recording the Key-Part
 Before recording the Key-part: locate to a time code location beyond the end of the recorded
video (Example: if the Video-part starts at 00:00:00:00 and ends at 00:10:00:00 locate to
01:00:00:00. To locate enter the time code value using the keypad and then press” Go To”)
 Press the REC button only to set the V1-HD in EE mode. (Displays the video on the input).
 If you see a valid video signal on your monitor, press REC and PLAY at the same time to
start recording. The time-code will start incrementing one the V1-HD is in record.
 Press STOP to finish the recording the Key-part.
Note: the V1 will record at the current position or at the end of file depending on the “Rec at:” setting
in OPTION MENU (01) “Transport”. For this operation set the “Rec at: to current position.
12.2.4 Merging the Video-part and the Key-Part
 Locate to the desired in-point of the Video-part recording and mark an IN point by pressing
the IN button.
 Locate to the desired Out-point of the Video-part recording and mark an Out-point by
pressing the Out button.
 Go to OPTION MENU (08) - Disk Copy
 Select Merge? And press Enter.
 The recording file name will be displayed.
 Press the ++ key the IN point will be displayed.
 Press the ++ key again the Out point will be displayed.
 Go out of the menu.
 Locate to a sync point on the Video-part recording. (The Sync-point S1 should be within the
marked IN and OUT points)
 Go back to the Menu.
 Press the ++ key the Sync-point S1 will be displayed.
 Press Enter to accept the S1 Sync-point.
 Go out of the menu.
 Locate to a sync point on the Key-part recording. (The Sync-point S2 should be within the
recorded Key-part video.)
 Go back to the Menu.
 Press the ++ key the Sync-point S2 will be displayed.
 Press Enter to accept the S2 Sync-point.
V_1.OM.000160.DRM Page 65 of 85 Version 5.2
Doremi Labs