Doremi MCSHD - Manual (Page 62)

12.1.2.2 Output Connections
 The Video-part output is on SDI Out-A1 and SDI Out-A2.
 The Key-part output is on SDI Out-B1 and SDI Out-B2.
Figure 25: SDI Video Output A and B Connection
12.1.2.3 Recording in Time Code Mode
To record using the Source Time-Code:
 The NDF/DF selection when creating the file (OPTION MENU (03) ”New Rec Set”) should
match the source time-code.
 Select “LTC” or “ATC” time-code (OPTION MENU (17)).
 Select “Time Code” in the Time Code Mode menu (MENU (02)).
 Press the REC button only to set the V1-HD in EE mode. (Displays the video on the input).
 If you see a valid video signal on your monitor, and if the displayed time-code is increasing
you can press REC and PLAY at the same time to start recording.
 Press STOP to finish the recording.
Note: The message “Wrong TC Fed” will be displayed in the following cases:
 The time-code fed is not detected.
 The selection of LTC/ATC is not the same as the time-code source.
 The NDF/DF file setting does not match the incoming time-code format (NDF/DF)
 The incoming time-code exceeds the time-line duration.
V_1.OM.000160.DRM Page 62 of 85 Version 5.2
Doremi Labs
SDI Video: Out-A1 and Out-A2
Video-part
SDI Video: Out-B1 and Out-B2
Key-part